Seal-Once Marine Premium Wood Sealer – Waterproof Sealant – Wood Stain and Sealer in One – 5 Gallon & Natural

Seal-Once Marine Premium Wood Sealer – Waterproof Sealant – Wood Stain and Sealer in One – 5 Gallon & Natural

• MARINE SEALANT: Our liquid formula creates a UV-stable coating for protection against the elements, saltwater spray, and water damage. Marine is a great protector for outdoor furniture, thermally modified wood, and boat docks. Marine is safe for use over open water and is non-hazardous to aquatic life.
• DECK STAIN: It’s water-based, ultra-low VOC, great for enhancing the extended life of your flooring, siding, and porch. The paint forms a water-resistant shield around wood fibers at the cellular level to help preserve the natural color.
• WATERPROOF WOOD SEALER: The wood used on boat docks, decks, and retaining walls near rivers, lakes, oceans, and ponds is subjected to constant moisture. We crafted a sealer, remove stain, and finish all in one, specifically for these installations.
• WOOD SEALANT: Our fast-drying protector penetrates wood below the surface, coating the wood fibers at the cellular level, which creates a long-lasting, flexible, breathable barrier. It provides a no-fuss, easy clean-up with soap and water.
• SEAL-ONCE: Our user-friendly wood sealers and stains are an effective way to protect your lumber or concrete against water damage. When you use Seal-Once, you have the satisfaction of knowing our products will not harm pets, plants, or people.

Directions
Do not use if air or surface temperature is below 45°F/7.22°C or above 95°F/35°C. Do not apply in rain or when rain is expected within 12-24 hours. DO NOT THIN. Mix well. Stir contents or shake thoroughly prior to use. Test a small area to ensure acceptable appearance and penetration. Apply first coat with a synthetic brush; pump-up garden sprayer; air-assisted; and/or airless sprayer. Use 15-17 tip and medium to coarse spray pattern. When spraying, always back brush for best results. Second coat can be applied once first coat has penetrated but is still damp. Second coat must be applied within one hour of applying first coat. For best results, apply in the shade and out of direct sunlight. When applying in direct sunlight and wood surface is hot, spray with a mist of water and apply SEAL-ONCE MARINE immediately on dampened surface. Apply to all surfaces. Do not use with other waterproofing products. Remove excess stain sitting or puddling on the surface. Back brush or use a rag to wipe away any runs, drips, or puddles that have not soaked in. Allow approximately 2-3 hours for surface to dry, depending on temperature and humidity, before subjecting surface to light foot traffic. Allow 12-24 hours for full cure, depending on temperature and humidity. When recoating, apply as soon as previous coat has penetrated and surface is damp, not wet. Second coat must be applied within one hour of applying first coat. Allow approximately 2-3 hours for surface to dry, depending on temperature and humidity, before subjecting surface to light foot traffic. Allow 12-24 hours for full cure, depending on temperature and humidity. When recoating, apply as soon as previous coat has penetrated and surface is damp, not wet. Second coat must be applied within one hour of applying first coat. Clean application equipment with warm soapy water. Disposal: soap and water cleanup; no special disposal procedure needed. Store above 32°F/0°C to protect from freezing. Shelf life (unopened): 3 years.

Product information

Technical Details